From the above I thought it might be stuck on the clock face itself, so I tried pulling/pushing the hand but no luck. Set the minute hand and any hardware there might be aside. I love the clock. When the hands are touching it usually means they are stuck and your clock will not run. If both hands are stuck, free the minute hand first, then the hour hand. A spring-powered clock has a ribbon, either metal, wire or plastic, that is coiled into a tight spiral... Hand Works. I have had other clocks that did the same thing and trashed them. I am sure it just needs a minor adjustment but I'm not sure what. Is there any way to fix this? If a little hand tinkering doesn't fix this problem, replacement battery powered clock mechanisms are cheap and readily available at craft stores, and it's a simple matter to replace the mechanism with a new one. The hour hand on my clock is loose and just falls back to the 6...? I have a couple of battery operated wall clocks with the same problem. Firmly grab the mounting point or “hub” of the hour hand and pull up. If this does not work, grab your trusty needle nosed pliers again. Place them under the hour hand were it mounts to the movement and gently rock back and forth … If you don't hear a ticking sound, the clock's hands are probably stuck. If your clock stops working, open the battery compartment on the back of the clock to remove the old battery. A minor bump shouldn't cause this much of a problem. It is time to give the Spring Driven Clocks clock a … Gently move the hands with a finger to see if they are touching the dial, the glass or each other. Many clocks have a third hand, which would normally be a second hand. It's battery operated and the minute and second hands move normally, it's just the hour hand that swings loose when I try to set it. If they are touching the "time train" may be jammed which prevents the pendulum from swinging. There are almost no exceptions. This works in most cases, where the issue is originated due to a system corruption. -If I push in near the center of the clock the hand moves but when I take my hand away it stops. Push the hour hand against the clock shaft. How to Fix Wrong Time on Clock in Windows 10 If the issue is with your Computer or a Laptop you should try using Reimage Plus which can scan the repositories and replace corrupt and missing files. one of the clocks is about 10 years old and worked fine for the first 8. Friction holds the hour hand on the shaft, and pushing it back onto the shaft will tighten it. Most clock repair starts with getting the clock hands off of the clock mechanism. How to Tighten Hands on a Clock. Often this problem can be fixed by adjusting both hands so they're pressed on just the right amount, and so they "clear" each other as they go around and around. Bend the stuck hand slightly to clear the obstacle.

Virtually all clocks have an hour hand (the short one) and a minute hand (the long one). Look at the hour and minute hands closely. Know Your Type. If these things do not fix the clock then it would be safe to assume there is a general lack of power in the time train. How to Tighten Hands on a Clock First Things First. Move the pendulum back and forth with your fingers. Tighten the nut on the end of the shaft holding the minute hand. It rotates quickly (once every minute). Can I repair my battery operated wall clock? To maintain a battery-powered quartz wall clock, make sure to replace the battery and reduce friction when needed. Use a damp q-tip or cotton ball to gently wipe down the terminals, then dry them with a clean cloth or towel. You should first assess the situation before you completely dismantle the inner workings of a clock. All hour hands on battery clock movements are the “press-on” type. the second hand sticks at a certain point, causing the clock to not keep time. If it bumps anything, even slightly, then it loses some momentum and the clock will eventually stop.