Answer / shubham sharma "noise margine is the max.

Noise Margin is the non-technical term for Signal to Noise Ratio Margin (SNRM). Noise margin moet volgens mij laag zijn, in jouw geval. The dynamic noise margin is measured by applying an interference pulse of known magnitude and increasing its width until the device just begins to switch.

set_noise_margin: NAME set_noise_margin Sets noise margin for a library pin, port, or pin. SYNTAX int set_noise_margin [-above] [-below] [-low] [-high] margin_value object_list float margin_value list object_list ARGUMENTS -above Specifies the noise margin for above ground or power rail noise … The value reported by these, unless they give both, is never the SNR (Signal to Noise Ratio).

The minimum output voltage of the driving device for logic high, V OH min, must be greater than the minimum input voltage, V IH min, of the receiving device for logical high. Domestic standard modems and ADSL routers often use the terms Noise Margin or SNR when reporting on its value. voh>vih>vil>vol vil=0,vol=0.
When very fast interference is present, higher amplitude is necessary to induce upset.

Dus de noise margin ziet er wel goed uit, echter heb je wel behoorlijk wat errors.
TVFool Canadian Discussion .

Meestal een kwestie van een goede korte aansluiting realiseren van je israpunt (waar het internet het huis binnenkomt) naar je modem toe. 17 Jan 2009 ... Hello everyone, reading tvFool more closely I saw their explanation for their Noise Margin column (NM dB).

Noise Margin, what good is this number - Inquiring minds want to know. The static noise margins as discussed above apply until the interference approaches the operating speed of the devices. voltage that can be added to the logic gate input which will not affect the output."

Here is their description: "The most ... www.highdefforum.com I punched in my exact coordinates in Montreal, post-transition, and selected digital channels only this time in Fool - and CBOt # 25, now appears, whereas before with digital and analog channels selected it didn't appear (only its analog #4), Mine was always running at around 6.3/6.0 but now suddenly it has gone to 6.3/9.8 :( Accordingly my connection speed has dropped too. As per the title , what is an acceptable noise margin in HH5 stats ?

Figure 2.12 illustrates noise margin and the terms, assuming that the signal generated by the driving device is wired to the input of the receiving device and that the wire is susceptible to noise.